Blade Guide for use in older style  DFS-100 work surfaces

• Use with standard DFS-100 ReefKeeper Band Saw with plastic table You should always install a new BladeSert™ Blade Guide (Stock no. 90012) whenever you install a new blade. The BladeSert™ will wear with saw use and the slot that the blade passes through will widen over time. Using a worn BladeSert™ allows for excess play in the blade and the blade becomes more likely to break. How fast this happens will depend on use and your sawing style. You should check the BladeSert™ for wear each time you use the saw. Immediately replace the BladeSert™ when it begins to show signs of widening and wear. You can use the "X" behind the slot as a wear guide. When the slot has worn out beyond the reach of the legs of the "X" it is time to replace the BladeSert. It is no longer providing proper support for your blade. The "X" also serves as reminder not to deflect the blade more than this amount in either direction.

This BladeSert fits the older style grey plastic work surface that shipped with saws up to September, 2001. That table style has been replaced by the new molded table, 90033, that uses a 90022 BladeSert.